DURETHANE® DTM is a surface tolerant, high solids, high build,two component acrylic urethane formulated for direct-to-metal applications. This product is compliant for applications in areas with VOC requirements of less than 250 g/L (2.08 lbs./gal.).
Albi 107A is a solvent based synthetic coating. Recognized as the standard of the industry, Albi 107A provides excellent fire retardant properties due to its special formulation of intumescent components. Designed for maximum protection of all combustible or noncombustible surfaces, it reacts to flame or heat at 300 degrees F by foaming into a thick cellular isolative blanket. This carbonaceous foam sharply limits the spread of flame and insulates the surface to which it is applied. Albi 107A reduces smoke development to low levels, critically important in assuring rapid escape from fire. Applied like conventional paint, this intumescent coating provides excellent durability and wear resistance, evidenced by wash, leaching and scrub ability tests.
Albi Cote 487S is a rust inhibitive, phenolic modified alkyd primer, designed as a shop coat or field primer for structural steel and other metal substrates. It has been specifically formulated for compatibility with Albi Intumescent Fireproofing materials, strong solvent base paints and mastics, which may lift or blister other primer coatings.
Albi 490W is a rust inhibitive, acrylic primer, designed as a shop coat or field primer for structural steel and other metal substrates. It has been specifically formulated for compatibility with Albi Intumescent Fireproofing materials, strong solvent base paints and mastics, where a water-based primer is preferred or required.
Albi 144 is a solvent based fire-inert alkyd coating, available in a semi-gloss finish. Designed for use on noncombustible surfaces and as a topcoat for fire retardant coatings, it minimizes the potential fire hazard of conventional paints. Applied like conventional paint, this durable coating provides a wear-resistant surface with excellent wash ability, without affecting the fire rating of the substrate to which it is applied. Albi 144 is available in a wide range of deep color hues on special order.
Albi Clad FP fireproofing brings the water-based, thin-film, intumescent coating characteristics of renowned Albi Clads to materials including wood, wallboard, plaster and other non-ferrous substrates. FP combines intumescent fire protection with the aesthetic breakthrough of an attractive, decorative, interior finish that preserves architectural detail on a range of materials. Albi Clad FP is used in historic restorations, condos, apartments, lofts and wherever architectural designs call for an extremely thin, aesthetic architectural finish with simultaneous fire protection. It may also be applied to correct fire ratings due to improperly installed wallboard.
Albi Clad TF fireproofing is a water-based, thin-film, intumescent coating that represents an aesthetic breakthrough in fire protection for exposed structural steel. It is a unique combination of intumescent fire protection and an attractive, decorative interior finish. Albi Clad TF is used in commercial buildings where architectural designs call for an extremely thin, aesthetic architectural finish with simultaneous fire protection for concrete or steel columns & beams.
Albi Clad 800 is a solvent based intumescent mastic coating applied to structural steel, concrete and other construction materials for exterior applications. It is UL classified for up to three hours of protection. Albi Clad 800 should be specified wherever long-lasting, exterior fireproofing is needed.